The Yaf_Route_Map class
(Yaf >=1.0.0)
Introduction
Yaf_Route_Map is a built-in route, it simply convert a URI endpoint (that part of the URI which comes after the base URI: see Yaf_Request_Abstract::setBaseUri()) to a controller name or action name(depends on the parameter passed to Yaf_Route_Map::__construct()) in following rule: A => controller A. A/B/C => controller A_B_C. A/B/C/D/E => controller A_B_C_D_E.
If the second parameter of Yaf_Route_Map::__construct() is specified, then only the part before delimiter of URI will used to routing, the part after it is used to routing request parameters (see the example section of Yaf_Route_Map::__construct()).
Class synopsis
class Yaf_Route_Map
implements
Yaf_Route_Interface {
/* Properties */
protected
$_ctl_router;
protected
$_delimiter;
/* Methods */
}Properties
- _ctl_router
- _delimiter
Table of Contents
- Yaf_Route_Map::assemble — Assemble a url
- Yaf_Route_Map::__construct — The __construct purpose
- Yaf_Route_Map::route — The route purpose
Here you can write a comment
There are no comments available yet.
